Victron Cyrix-Li-charge Intelligent Charge Relay 24/48V-120A CYR020120430
The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay: €“ if the Charge Disconnect output of the VE.Bus BMS is high, and €“ if it senses 13,7V (resp. 27,4V or 54,8V) or more on its battery charger connection terminal, and €“ if it senses 2V or more on its battery terminal (the Cyrix will remain open, if not connect to the battery). The Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature. In general a cell over voltage alarm will reset shortly after charging has been stopped. The Cyrix will then reconnect the charger after a delay of 3 seconds. After two attempts to reengage with 3 seconds delay, the delay increases to 10 minutes. Whenever battery voltage is less than 13,5V (resp. 27V or 54V), the Cyrix will disengage with a delay of 1 hour. Note 1: In case of zero discharge current, or a small discharge current, the Cyrix will not disengage shortly after the charger has been switched off and/or disconnected, because battery voltage will remain higher than 13,5V. Note 2: If, after the Cyrix has disengaged, the output of the battery charger immediately increases to 13,7V or more, the Cyrix will re-engage, with 3 seconds delay Technical Specifications Brand Victron Energy Manufacturer Part Number CYR020120430 Voltage 24/48 Continuous current & Breaking capacity at 12V or
Amps Range: 90+A |
Internal Reference:
105631
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.